QUALIFICATIONS: -Discuss rules and regulations, and safety hazards -Show video of rules and regulations, and safety hazards -Hand out rule books and behavior contracts QUALIFICATIONS: *Installed and removed rubber, k-lo, hull board, Polymide, Rubatex, fire mask blanket, spray shields, and pads on pipes and bulkhead as needed *Make pads using tin-mat hull board, soft insulation (fiber glass) to go around vents and pipes *Tape, lagging, on insulation *Put hull board up 1 inch, 2 inch, (thermal and AC) where needed *Installed 3 inch, 6 inch thermal on troughs *Cemented, stapled, wired, taped, and sprayed insulation *Covered steam pipes, measured and cut sections of insulation to the proper length *Fastened the insulation with adhesive, staples, tape, and/or wire bands *Clean work area I have insulated the following: -AC pumps -Steam Generators -LO Pumps - Main feed pumps - Main Steam Valves -Various types of ventilation -Hot, Cold and Chill Water -High Pressure Steam QUALIFICATIONS: *Roll and brush painting *Prep space to paint it by putting plastic round furniture and other places that needed it *Paint walls or bulkheads or other structural surfaces *Ingredients mix paint, or chemicals, according to specifications *Use scraper to knock off loose paint *Smoothes surfaces to be painted using wire brush, grinder, and sandpaper *Remove finish from walls, bulkheads, or related structures

Highlights:

• Grinder
• Information Technology
• Install
• Mask
• Painter
• Quality
• Quality Assurance
• Valves